Os-engines 32SX-HX Instrukcja Użytkownika

It is of vital importance, before attempting to operate your engine, to read the general 'SAFETY INSTRUCTIONS AND WARNINGS' section on pages

3 Glowplug batteryThe power source for heating the glowplug may be either a large heavy-duty 1.5volt dry cell, or preferably, a 2-volt rechargeable l

Fuel Can Filter12V BatteryStarter7 Fuel container filterInstall a filter on the outlet tube of your refuelling container to prevent entry of foreign

Install a plug suitable for the engine.Use fuel containing a moderate percentage of nitromethane.Do not run the engine too lean and do not leave the b

CARBURETOR CONTROLSWith a fixed-wing model, power failure is rarely a serious threat to the safety of the aircraft since it can usually glide down to

STARTING (32SX-H / SX-H RING)Open the throttle fully, and turn the engine using an electric starter until the fuel is seen to reach the carburetor. Fu

Connect the battery to the glowplug and pull the start knob smartly.6.NOTE:If the throttle response is poor or the engine stops due to a temporarily o

This enables the full r.p.m. range, from idling to full power, to be controlled by the throttle stick, and then allows the engine to be stopped, from

Hover the model and actuate the throttle to observe response over the medium speed range. lf the engine smokes excessiveIy and throttle response is po

OReadjustments should therefore be carried out as follows:lf the mid-range throttle response is not rapid and positive (indicating a rich mid-range mi

CARBURETOR CLEANLINESSThe correct functioning of the carburetor depends on its small fuel orifices remaining clear. The minute particles of foreign ma

CONTENTSSAFETY INSTRUCTIONS AND WARNINGS ABOUT YOUR O.S. ENGINEINTRODUCTIONBASIC ENGINE PARTS,INSTALLATIONNOTES CONCERNINGTHE RECOIL STARTERBEFORE STA

ADJUSTING CHARTOpen the Needle Valve 1-1/2 turns from the fully closed position.Make sure that the Mixture Control Valve is at the factory setting.ASt

INSTALLATION OF THROTTLE SERVOAfter the engine in the helicopter, please observe the following recommendations when linking the throttle servo to the

CARE AND MAINTENANCEThe minute particles of foreign matter, that are present in any fuel may, by accumulating and partially obstructing fuel flow, cau

trewq=-09876543215-25-1N.+M3.5X5C.M2.6X7C.M2.6X12Type of screw C…Cap Screw M…Oval Fillister-Head ScrewF…Flat Head Screw N…Round Head Screw S…Set Sc

No.123455-15-267890-=qwert2340400023403000234060002340500023481000226150002308170623210007226200032283100023401000234300002340200023414000229070002241

ytrewq=-09876543217-27-1y-2y-1uC.M2.6X12N.+M3.5X5F.M2.6X10N.+M3X8EXPLODED VIEW (MAX-32SX-HXRING)Type of screw C…Cap Screw M…Oval Fillister-Head Screw

ENGINE PARTS LIST (MAX- 32SX-HXRING)The specifications are subject to alteration for improvement without notice.No.12345677-17-2890-=qwertyy-1y-2u2340

CARBURETTOER PARTS LIST & EXPLODED VIEWNo.11-11-223455-167899-19-29-39-49-50-234814002278141022781420227814112348120023481650234811002488182426781

MAX-32SX-H/32SX-HRING THREE VIEW DRAWING Displacement Bore Stroke Practical R.P.M. Power output Weight5.23 cc (0.319 cu.in.)19.5mm (0.768 in.)17.5m

MAX-32SX-HXRING THREE VIEW DRAWING Displacement Bore Stroke Practical R.P.M. Power output Weight5.23 cc (0.319 cu.in.)19.5mm (0.768 in.)17.5mm (0.6

Remember that your engine is not a "toy", but a highly efficient internal-combustion machine whose power is capable of harming you, or other

O.S. GENUINE PARTS & ACCESSORIES DRIVE HUB(23408000) (23325020) E-3030 SILENCER(23325100) (22625508) CRANKSHAFT CLAMP3261 (For 32F-H, SX-H,

MEMO30

C Copyright 2000 by O.S.Engines Mfg. Co., Ltd. All rights reserved. Printed in Japan.UNEQUALLEDQUALITYPRECISION&PERFORMANCEESTABLISHINGTHESTANDAR

WARNINGS•••••Never touch, or allow any object to come into contact with, the rotating parts.Model engine fuel is poison-ous. Do not allow it to come i

NOTES•••••These engine were designed for model helicopters. Do not attempt to use it for any other purpose.Mount the engine in your model securely, fo

NOTES••••••Take care that loose clothing (ties, shirt sleeves, scarves etc.) do not come into contact with the rotor. Do not carry loose objects (such

Because of this initial tightness, a standard electric starter may have difficulty in rotating the engine when cold, before it has been adequately run

BASIC ENGINE PARTSHeatsink HeadCarburetorTypr 20C CrankshaftPropeller nutCrankcaseNeedle valveGlowplugBeam MountRecoil Starter Assembly No.OMAX-32SX-H

As the recoil starter is of unit construction, re-placement parts are not available. Replace-ment recoil starters are obtainable only as complete unit