Os-engines FT-160 Gemini Instrukcja Użytkownika

It is of vital importance, before attempting to operate your engine, to read the general 'SAFETY INSTRUCTIONS AND WARNINGS' section on page

18Adjust the needle-valve10.Abrupt adjustment of the needle-valve may cause the engine to stop, especially when it is new and insufficiently run-in.As

20Start the engine.open the throttle fully .Adjust the neede-valve.Close the throttle gradually.Find the idling position.Fix the idling position.Open

21+Adjusting the mixture control valveIf the engine hesitates, puffing out a good deal of smoke, before picking up to full speed, it is probable that

23VALVE CLEARANCE ADJUSTMENTRemove the rocker cover from each cylinder head by unscrewing two socket-head cap-screws from the rocker box on top of the

25Remove 0.04mm feeler, rotate prop through two revolutions and recheck gap.5.If clearance is correct, loosen the locknut on the other rocker-arm and

26EXPLODED VIEWType of screw C...Cap Screw M...Oval Fillister-Head ScrewF...Flat Head Screw N...Round Head Screw S...Set ScrewM3C.M2.6x7C.M3.5x20C.

282638150124981405263815014648132022781800464813302638150146481200462813404648131022781800464811004628190029081952249818372638150146181940461819414618

3013.26cc x 2 / 1.218cu.in. x 227.7mm / 1.091in.22.0mm / 0.866in.2.000-10.000r.p.m.1,100g / 38.8oz.23.550.563.54 -5.256.5196546812076THREE VIEW DRAW

2Remember that your engine is not a " toy ", but a highly efficient internal-combustion machine whose power is capable of harming you, or ot

4Take care that the glow plug clip or battery leads do not come into contact with the propeller. Also check the linkage to the throttle arm. A disconn

6ENGINE PARTS NAMERocker CoverGlow PlugLock NutDrive HubPropeller WasherCrankcaseCarburetorExhaust PipePropeller NutCylinder HeadLeft (No.1) CylinderR

8It is essential that the firewall is strong and rigid (e.g. at least 15mm thick) and firmly integrated with the structure of the aircraft.INSTALLATI

1016x8, 18x6-8, 20x6CarburetorThe needle-valve and throttle lever locations are interchangeable by reversing the carburetor. This can be done as follo

12GLOWPLUGSThe role of the glowplugGlowplug lifeParticularly in the case of very high performance engines, glowplugs must be regarded as expendable i

14Glowplug leadsFig.12Switch should have sufficient capacity.The plug leads are fitted with special snap-on connectors that ensure firm contact with O

16Make sure that glowplugs are not connected to the battery. Do not heat the glowplugs while priming. (Fig.15).2.Fig.15Do not connect the battery toth